Graco 17A226 Use and Care Manual download pdf (Page 13)

Cleanup

333394E 13

Cleanup

Pressure Relief Procedure

Follow the Pressure Relief Proce-

dure whenever you see this symbol.

1. Disconnect power (unplug power cord).

2. Turn Prime Pump/Spray Knob down to

PRIME PUMP position to relieve pres-

sure.

Cleaning Sprayer

Cleaning your sprayer properly and after every

spray job is of the utmost importance! Proper

care and maintenance will make your paint

sprayer last and work for you trouble free.

1. Turn Prime Pump/Spray knob to Prime

Pump to relieve pressure.

2. Separate the cup support with FlexLiner

from the cup cover/sprayer.

Use only water-based or oil-based

(mineral spirit-type) materials with flash

point greater than 100° F (38° C).

Do not

use materials which state “FLAMMABLE”

on the packaging. For more information

about your material, request MSDS from

distributor or retailer.

Clean in a well-ventilated area.

Keep a

good supply of fresh air moving through the

area.

To avoid serious injury or damage to

equipment, do not expose the sprayer

electronics to cleaning fluids. Keep sprayer

at least 10 in. (25 cm)

above the rim of the

container when cleaning.

This sprayer builds up an internal

pressure of 2000 psi (14 MPa, 138 bar)

during use. Follow this

Pressure Relief

Procedure

whenever you stop spraying

and before cleaning, checking, servicing,

or transporting equipment to prevent

serious injury.

ti23408a

ti23285a

Prime Pump

ti23385a

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Comments to this Manuals

No comments