INSTRUCTIONS-PARTS LIST OJ 307-896 This manual contains IMPORTANT WARNINGS and INSTRUCTIONS READ AND RETAIN FOR REFERENCE AUTOMATIC HIGH-RANGE ELECTR
ELECTRICAL TROUBLESHOOTING CHART PROBLEM CAUSE SOLUTION Poor wrap-around. Parts poorly grounded. Clean hangers, check for proper ground on conveyer
ELECTRICAL TROUBLESHOOTING CHART PROBLEM CAUSE SOLUTION Low or no electrostatic Spring at transformer end of cable Stretch spring. wrap. (Spraying vol
Fluid Needle Removal (See Figs 7 and 8) Remove the air cap and fluid tip as described in the Operation Section under Clean the Air Cap and Flu
KEY 4 Packing 20 SupPOrt 66 O-Ring 67 O-Ring n Fitting 23 Packing Nut 28~~ \ 28 Barrel Nut ~~~ 29 Support ~,~ 44 Insulator 20~ ~ 60 Gun earrel 6I~ c:
Replace the barrel as described in Barrel Reas.embly. Reassemble the electrode resistor (55), fluid tip (30), and air cap (32) as described in Clea
AIR CAP CONSUMPTION AND FLUID TIP FLOW RATE CHART ___ Dm __ WMmmlHS1i~gt*i]rn1Jm1~n:;;;%bWiitHfWJ NOTE: This is only a guide for selecting an air cap
a; Repair Kit 218-988 Must be ordered separately. ~ Consists of: ... I Q) <0 0) Ref No. 4 6 7 8 10 14 16 20 24 29 58 66 67 72 60 Qty. 2 3 1 2 2
REF PART NO. NO. 4 *105-662 6 *103-338 7 *105-668 8 *105-796 9 105-797 10 *105-798 11 104-765 12 105-800 13 105-801 14 *598-706 15 106-144 16
...------WARNING------, Never operate your equipment at a working pressure rating that is higher than the lowest rated component in your system. L
ACCESSO A I ES (Must be purchased separately) nmMmtW*iimim::ti/@Mm:N?HM1mtJM:Wt:tiIrl:i::fil:·:: •• ·:~:@Wi.{<:\·/?::)i· The accesaori .. on this p
TABLE OF CONTENTS WARNINGS ... 2 HOW THE ELECTROSTATIC AIR SPRAY GUN WORKS ...
,I I -n cm t--I: ---33~~·5in.) ... ·-------------(13 In.'-------------I 17 cm (6.7 in.' 44 em 1--------------------(17.3 in.' TECHNICA
Bleed· Type AIr Shutoff Valve and fluid Drain Valve Required These two accessories are required in your system to help reduce the risk of serious
How the Electrostatic Air Spray Gun Works A transformer supplies high voltage current through the cable to the gun's ionizing electrode, where t
Connect the High Voltage Power Supply The electrical connections to the Power Supply (H) must be performed by a qualified electrician, in accor
Connect the High Voltage Control An electrical signal is required to actuate the normally closed, 3-way air solenoid valve (P). The air solenoid
39 KEY 39 Fluid Adjusting Screw fi1 Fan Valve Assembly Fig 4 ________________ _ NOTE: When increasing to a wide, flat pattern, you may have to incre
SERVICE ~----------------------------VVARNING----------------------------~ Installing and servicing this equipment requires access to parts which may
GUN OPERATION TROUBLESHOOTING CHART PROBLEM CAUSE SOLUTION Leakage from fluid packing nut. Loose packing nut (23). Tighten. Worn needle packing (4).
Comments to this Manuals