Graco SnugRide Click Connect 35 User Manual download pdf (Page 18)

To Install Locking Clip:

1. Tighten the buckled belt by pushing down

hard on the infant restraint and pulling hard

on the shoulder belt.

2. While pushing down on the infant restraint,

pinch the two straps together behind the

buckle tongue. Unbuckle the belt

without allowing it to slip.

3. Connect lap and shoulder belts with locking clip as

shown  and .

4. Rebuckle belt. Check that lap belt does not

move by pulling and push-

ing hard on the infant

restraint.

If belt loosens or

lengthens, repeat

procedure.

Locking clip

 Combination Lap/Shoulder

Belt with Sliding Latch

Plate

This belt has a latch plate that slides

freely along the belt.

This belt MUST be converted to prevent

movement of the lap portion of the belt.

You must use a locking clip (provided

with the infant restraint) when using the

infant restraint without the base unless

your vehicle’s seat belt can be

converted in another way as described

in your vehicle owner’s manual.

/2 inch

(1 cm)



Locking clip goes here,

/2 inch (1 cm) from the buckle



1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 95 96

No comments

Graco SnugRide Click Connect 35 User Manual Page 18