Graco 312054J User Manual download pdf (Page 13)

Installation

312054J 13

Adjusting Grease Output Volume

If a meter is not producing the correct amount of lubri-

cant for a specific location on a vehicle or if a replace-

ment meter of correct size is not available, output

spacer washers can be installed to adjust the meter’s

output volume.

Use Table 1 to determine which size meter is appropri-

ate for the grease location.

To change output volume:

1. Relieve pressure, page 15.

2. If the meter is located on a manifold, use a 7/16”

wrench to remove tubing (F

IG. 13).

3. Use a 5/8” deep well socket to remove meter from

manifold (F

IG. 14).

4. Place meter in a vise, output end (tube connector)

facing up.

5. Use two 5/8” wrenches to separate the meter

halves.

6. Separate the meter body from the valve assembly.

Be careful not to misplace or damage springs and/or

TABLE 1: Meter Identification and Usage

Meter

Size

Number of

Washers

Hex

Flat

Output

(in.

)

Recommendations for

Specific Lubrication Points

0 No 0.002 Brake Shafts, transmissions, cross shafts, “S” cams

1 No 0.005 Slack adjusters, 5th wheel pivot, and miscellaneous points

2 No 0.009 Drag link, tie rod ends, power steering linkage

3 No 0.012 Kin pins, spring pins, spring shackles

4 No 0.020 Misceallenous points

4 Yes 0.026 5th Wheel plate

*Size 8 high output meters cannot

be changed.

FIG. 13

FIG. 14

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Comments to this Manuals

No comments

Graco 312054J User Manual Page 13

Comments to this Manuals